Adjusting The Mowing Height - Dolmar AM-3743 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
Battery indicator status
On
Indicating the remaining battery
capacity
Only for battery cartridges with "B" at the end of the
model number
► Fig.5: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for few seconds.
Indicator lamps
Lighted
Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Switch action
WARNING:
Before installing the battery car-
tridge, always check to see that the switch lever
actuates properly and returns to the original posi-
tion when released. Operating a tool with a switch
that does not actuate properly can lead to loss of
control and serious personal injury.
NOTE: The mower does not start without pressing the
switch button even the switch lever is pulled.
NOTE: Mower may not start due to the overload
when you try to mow long or dense grass at a time.
Increase the mowing height in this case.
This mower is equipped with the interlock switch and
handle switch. If you notice anything unusual with either
of these switches, stop operation immediately and
have them checked by your nearest Dolmar Authorized
Service Center.
Remaining battery
capacity
Off
0% - 20%
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
1.
Install the battery cartridges. Insert the lock key
into the interlock switch and then close the battery
cover.
► Fig.6: 1. Battery cartridge 2. Lock key
2.
Press the switch button and hold it.
3.
Grab the upper handle and pull the switch lever.
► Fig.7: 1. Switch button 2. Switch lever
4.
Release the switch button as soon as the motor
starts running. The mower will continue to run until you
release the switch lever.
5.
Release the switch lever to stop the motor.

Adjusting the mowing height

WARNING:
the mower body when adjusting the mowing
height.
WARNING:
fits in the groove properly before operation.
The mowing height can be adjusted in the range of
between 20 mm - 75 mm.
1.
Remove the lock key.
2.
Pull the mowing height adjusting lever to the
outward of the mower body and move it to your desired
mowing height.
► Fig.8: 1. Mowing height adjusting lever
NOTE: The mowing height figures should be used
just as a guideline. Depending on the conditions of
the lawn or the ground, the actual lawn height may
become slightly different from the set height.
NOTE: Try a test mowing of grass in a less conspicu-
ous place to get your desired height.
Grass level indicator
► Fig.9: 1. Grass level indicator
Grass level indicator shows the volume of mowed
grass.
When the grass basket is not full, the indicator
floats during mowing.
When the grass basket is full, the indicator does
not float during mowing. In this case, stop mowing
immediately and empty the basket. After emptying
the basket, clean it so that its meshwork vents the
air.
NOTE: This indicator is a rough guide. Depending on
the conditions of inside of the basket, this indicator
may not work properly.
10 ENGLISH
Never put your hand or leg under
Always make sure that the lever
Tabla de contenido
loading

Tabla de contenido