Height Adjustment; Angle Adjustment - Festool ST TKS 80 Instrucciones De Montaje

4.6

Height adjustment

► Open the rotary knob screws [5-3].
► Open the hexagon socket screws [5-8] until
the stop rail of the preset profile setting
rail [5-5] protrudes approx. 1 mm from the
saw table [5-10].
► Tighten the rotary knob screws [5-3].
4.7

Angle adjustment

► Turn the hexagon socket screws [5-8] until
the support surface of the slide [5-7] is
parallel to the table surface of the saw
table [5-10].
Checking the parallelism: Place a ruler
over the support surface of the
slide [5-7] and the table surface of the
saw table [5-10].
5 Transportation
► Clamp the slide [4-4] to the guide rail [4-2]
with rotary knob screws [4-1].
6 Accessories
Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festool.co.uk.
7 Environment
Do not dispose of accessories in the
household waste. Recycle accessories
and packaging. Observe applicable
national regulations.
Information on REACH: www.festool.com/reach
English
9