Extension Cord; Switching On/Off; Settings - Festool OF 1010 REQ-F Instrucciones De Uso Original

English
2
7.1

Extension Cord

If an extension cord is required, it must have
sufficient cross-section to prevent an excessive
drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead
to failure of the motor. The table below shows
you the correct cord diameter as a function of
the cord length for this tool.
Cord Size in A.W.G
Tool`s Ampere Rating
3-6
6-8
8-10
10-12
12-16
Wire Sizes in mm
2
Tool`s Ampere Rat­
ing
3-6
6-8
8-10
10-12
12-16
Use only NRTL listed extension cords.
Never use two extension cords together. In­
stead, use one long one.
10
Cord Length in Feet
25 50 100 150
18 16 16 14
18 16 14 12
18 16 14 12
16 16 14 12
14 12 - -
Cord Length in Meters
15 30 60 120
0.75 0.75 1.5 2.5
0.75 1.0 2.5 4.0
0.75 1.0 2.5 4.0
1.0 2.5 4.0 -
- - - -
The lower the AWG number, the stronger
the cord.
7.2

Switching on/off

The switch [1-14] is an on/off switch (press =
ON, release = OFF).
The on/off switch with the locking button [1-12]
can be engaged to operate in continuous mode.
Press the on/off switch again to release the
lock.
8

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
8.1 Electronics
Speed adjustment
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-11] (see "Technical data").
This enables you to optimise the cutting speed
to suit each surface.
Materi­ Cutterdiameter
al
1/8" - 5/8" -
1/2"
3 - 14 15 - 25
mm mm
Rotary controll setting
Hard­ 6 - 4 5 - 3
wood
Soft­ 6 - 5 6 - 3
wood
Lami­ 6 - 5 6 - 3
nated chip­
board
Plastic 6 - 4 5 - 3
Alumi­ 3 - 1 2 - 1
nium
Plaster­ 2 - 1
board
Temperature cut-out
Electronic temperature monitoring is integrat­
ed in order to protect against overheating (mo­
tor burnout). The safety electronics system
switches off the motor before a critical motor
temperature is reached. Let the machine cool
Recom­
mended
1-1/8" -
cutter
1" 1-3/8"
material
26 - 35
mm
3 - 1 HW (HSS)
4 - 1 HSS (HW)
4 - 2 HW
2 - 1 HW
1 HSS (HW)
1 1 HW