Settings; Activating The Settings Menu; Beep; Units - Hilti PD4 Manual De Instrucciones

Printed: 07.07.2013 | Doc-Nr: PUB / 5070017 / 000 / 00
Aim the visible laser spot at a target.
Press the "Measure" key again.
The distance will be shown in less than 1 second, e.g. 5.489 m.
You have taken the first distance measurement with the
PD 4 laser range meter.

5.3. Settings

5.3.1 Activating the Settings menu

The menu is activated by pressing the "On / Off" key for
more than 2 seconds while the range meter is switched off.

5.3.1.1 Beep

As you enter the "Menu" the beep option is displayed. Press
the "Measure" key to toggle between "On" and "Off"

5.3.1.2 Units

The units of measurement may be set by pressing the "On/Off"
key once. Scroll through the various units of measure by
pressing the "Measure" key.
The units of measure are shown below.
Setting Distance
m meters
mm millimeters
ft feet (decimal)
yd yard (decimal)
in inch (decimal)
in 1/8 inch 1/8
in 1/16 inch 1/16
ft 1/8 feet & inch 1/8
ft 1/16 feet & inch 1/16

5.4 Exiting the menu

Exit "Menu" by a 2 second press of the "On/Off" key.

6. Operation

6.1 General controls

6.1.1 Control panel

6.1.2 On/off key

• switches the range meter on and off.

6.1.3 "Measure" key

• switches the range meter On
• activates the laser beam for aiming at the target,
• activates single distance measurement
• activates and deactivates continuous distance measure-
ment.

6.2 Display

The display shows the measurements, settings and range
meter status.
In the measuring mode, the latest readings are shown in the
lowest display line (result line) and the prior readings in the
lines above (intermediate result lines).
en
19