Operation; Premixed Fuel; To Mix Fuel; To Examine Before Start - McCulloch B26PS Manual De Usuario

Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Fuel
This product has a two-stroke engine.
CAUTION: Incorrect type of fuel can result in
engine damage. Use a mixture of gasoline
and two-stroke oil.

Premixed fuel

• Use Husqvarna premixed alkylate fuel of a good
quality, for best performance and extension of the
engine life. This fuel contains less harmful chemicals
compared to regular fuel, which decreases harmful
exhaust fumes. The quantity of remains after
combustion is lower with this fuel, which keeps the
components of the engine more clean.

To mix fuel

Gasoline
• Use good quality unleaded gasoline with a maximum
of 10% ethanol contents.
CAUTION: Do not use gasoline with an
octane grade less than 90 RON/87 AKI.
Use of a lower octane grade can cause
engine knocking, which causes engine
damages.
• We recommend that you use gasoline of a higher
octane grade for work with continuously high rpm.
Two-stroke oil
• For best results and performance use Husqvarna
two-stroke oil.
• If Husqvarna two-stroke oil is not available, use a
two-stroke oil of good quality for air-cooled engines.
Speak to your servicing dealer to select the correct
oil.
CAUTION: Do not use two-stroke oil for
water-cooled outboard engines, also
referred to as outboard oil. Do not use oil
for four-stroke engines.
To mix gasoline and two-stroke oil
Gasoline, liter
1228 - 001 - 12.07.2019

Operation

5
10
15
20
(Fig. 50)
1. Fill half the quantity of gasoline in a clean container
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
5. Carefully shake the fuel mixture.
To fill the fuel tank
1. Clean the area around the fuel tank cap. (Fig. 51)
2. Shake the container and make sure that the fuel is
3. Remove the fuel tank cap and fill the fuel tank.
4. Tighten the fuel tank cap carefully.
5. Move the product 3 m/10 ft or more away from the
Note: To see where the fuel tank is on your product,
refer to

To examine before start

1. Make sure that the product has no missing,
2. Make sure that nuts, screws and bolts are tightened.
3. Make sure that the blades or trimmer head is not
4. Make sure that the locknut is tightened. Refer to
Two-stroke oil,
liter
5. Make sure that the air filter is not clogged.
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
for fuel.
container.
CAUTION: Do not mix fuel for more than 1
month at a time.
fully mixed.
refueling area and fuel source before you start the
engine.
Product overview on page 6 .
damaged, loose or worn parts.
damaged.
attach and remove the locknut on page 10 .
2% (50:1)
0.10
0.20
0.30
0.40
To
13