Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
OPERATIONAL PARAMETERS
Electric chain hoists are manufactured in accordance with the latest technical developments along
with the latest technical safety regulations and specifications, and are tested for safety by the
manufacturer. The operational parameters of the electric chain hoist also encompass the compliance
of the safe operating practices, maintenance information and parts information manuals.
The operational parameters do not include:
● Exceeding the defined load capacity,
● Diagonal pulling of the load or yarding,
● Excessive impact or lifting of guided loads.
Excessive inching operations, ground mooring and running against limit switches, should be avoided.
Operating temperature is -15° to 50° C ( 5° F to 122° F).
Hoists are rated at H4 Duty Class in accordance with ASME HST-1-2012.
The manufacturer accepts no responsibility for any damage to this equipment, resulting from
abnormal operating practices.
START-UP
DANGER
Mechanical adjustments should be performed by authorized designated personnel.
CAUTION
The operating staff must carefully read the operating instructions of the electric chain hoists
before its initial operation and carry out all checks. Only when a safe operation has been
established may the device be put into operation. Unauthorized persons may not operate the
device or perform any work with the help of the same.
Transport and Assembly
For the transport and assembly of the electric chain hoists, the safety direction for handling with
loads are to be followed. Refer to Product Safety Information Manual.
The electric chain hoists must be assembled by qualified staff, always bearing in mind the accident
prevention directions. Before assembly the electric chain hoist must be stored in an enclosed
room or covered area. Should the electric chain hoist be destined for operation outdoors, then it
is recommended that a protection roof is erected to shield it from the influences of the weather.
Whenever possible, the electric chain hoist should be transported in its original packaging. It is
recommended that the assembly and connection of the electric chain hoist is conducted on-site
by qualified personnel.
Form 47584686001 Edition 5
7
Tabla de contenido
