Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Most laundering problems are easily solved if you understand the cause.
Check these lists for common laundry and washer problems. If you need
further assistance, see page 40.
Problem
Possible Cause
Solution
Washer Leaks
Household plumbing is leaking.
Repair plumbing.
inlet hoses not tight.
Tighten hoses (see "Installation
instructions," Sections D & E).
inlet hose washers not
Reseat washers (see "Installation
properly seated,
instructions," Section D).
Drain hose not properly
Clamp drain hose (see "installation
clamped or is off.
instructions," Section C).
Drain is dogged.
Remove drain dogs. Sink, standpipe,
or floor drain must be able to handle
17 gal (64 L) of water per minute.
Tub moved forward during
Ensure tub is centered before
unloading, causing water to
starting washer.
deflect off tub ring.
Unit not level causing water
Ensure front feet are installed and
to deflect off tub ring.
nuts are tightened. Level washer.
Reset rear legs (see "Installation
Instructions," Section G).
Load is unbalanced. Spray
Redistribute the load.
rinses are deflecting off load.
Washer is overloaded. Fills or
Reduce load size.
spray rinses are deflecting off
load.
Won't Drain/
Drain hose is kinked or
Straighten or unplug hose (see
Won't Spin/
clogged.
"installation instructions," Section C).
Wet Loads
Correct operation of
After a wash or rinse, the washer will
neutral drain,
drain without spinning. After draining,
the spinning begins.
Lid is open.
Close the lid.
Drain hose is more than
Lower drain hose (see "Installation
96 in (2.4 m) above floor,
instructions," Section A).
Too much detergent -
Use less detergent.
excessive sudsing.
Wrong cycle for load
Choose a cycle with a higher spin
being washed,
speed (see "Operating Your
Washer").
35
Tabla de contenido
