Tabla de contenido
Idiomas disponibles
Idiomas disponibles
USING
THE LiQUiD
FABRIC
SOFTENER
DISPENSER
After loading the washer, measure and
add the recommended amount of fabric
softener into the dispenser. Follow
manufacturer's directions.
NOTE: Pouring too much fabric softener
into the dispenser wilt cause the fabric
softener to dispense instantly into the
load due to siphoning action. This
instant "dump" could damage fabrics
and will make it appear that your
dispenser is not working correctly.
To remove the Fabric Softener
Dispenser for cleaning:
STEP 1. Pull the blue lock ring up,
then remove dispenser from agitator
by pulling up.
STEP 2. Flush the dispenser with
warm water.
To replace the Fabric Softener
Dispenser:
STEP 1. Be sure the blue lock ring
is pulled up. Starting at an angle (see
illustration), push the bottom d the
dispenser down on the agitator top.
STEP 2. When the dispenser is seated
on the agitator, push the blue lock ring
down until it snaps in place. It must fit
tightly.
Liquid fabric softener
dispenser
....Blue10ck ring
Add warm water to fitt the dispenser
until it reaches the crossed opening at
the bottom of the funnel-shaped
portion
of the dispenser.
Fabric softener is dispensed into the
first deep rinse water automatically.
NOTE: Fabric softeners are not com-
patible with detergents. This dispenser
should never be used in the PREWASH
Cycle since it would dispense fabric
softener into a wash load that has not
been rinsed. Undiluted fabric softener
spilled on fabric may result in spots that
look like oil stains.
If you ever use your dispenser this way
by mistake, rewash the load with extra
detergent to remove these deposits.
3O
Tabla de contenido
