Remove Shipping Strap - Sears Kenmore 3953631 Manual Del Propietário

B. REMOVE SHiPPiNG STRAP
Ft ej=-m1,_P" - t=,] a[_ I"["
Removing the shipping strap is
necessary for smooth
operation.
If the shipping strap is not removed,
the washer will make excessive noise.
Excessive Weight Hazard
Use two or more people to
move and install washer.
Failure to do so can result in
back or other injury.
To prevent floor damage, set washer
onto cardboard before moving across
floor. Move washer close to its final
location.
STEP 1. Do not cut yellow strap. Pull
yellow strap firmly, until completely
removed from washer. Depending on
your model, there will be either two or
three cotter pins on the end of the
shipping strap when it is pulled out of the
washer. The electrical plug is attached to
this shipping strap.
Electrical plug
STEP 2. Putt firmly to remove the end
of the shipping strap that remains
pinned to the back of the washer. This
will release the rear self-leveling legs.
Pin
STEP 3. Cut the shipping strap about
16 in (40 cm) from plug end. Look for
the words "CUT HERE." Discard end
with three cotter pins. Slide remainder
of shipping strap from the electrical
plug. You will use this to secure the
drain hose.
16 in
Shippingstrap
14
Pin