Porter Cable PCC670 Manual De Instrucciones página 51

WARNING:
to Reduce tHe RISk of INjuRy
Never hold the piece being cut with your hands or lay
it across your leg (figure f).
Secure the workpiece to a stable platform as shown in
figure G. It is important to support the work properly
to minimize body exposure, blade binding, or loss of
control.
cuttING dePtH AdjuStMeNt -
fIGuReS H & I
The depth of cut should be set according to the
thickness of the workpiece.
• Loosen the depth adjustment knob (11) to unlock the
saw shoe (5) as shown in figure H.
• Move the saw shoe into the desired position. The
corresponding depth of cut can be read from the scale (14).
• Set depth adjustment of saw such that one tooth (15)
of the blade projects below the workpiece (16) as
shown in figure I.
• Tighten the knob to lock the saw shoe in place.
Bevel ANGle AdjuStMeNt -
fIGuRe j
This tool can be set to bevel angles between 0° and 50°.
• Loosen the bevel adjustment knob (10) to unlock the
saw shoe (5).
• Move the saw shoe (5) into the desired position. The
corresponding bevel angle can be read from the scale (17).
• Tighten the bevel adjustment knob (10) to lock the
saw shoe in place.
• Confirm the accuracy of the setting by checking the
bevel angle of an actual cut on a scrap piece of material.
SHoe AdjuStMeNt foR 90° cutS
The shoe (5) has been set by the factory to assure that the
blade is perpendicular to the shoe at 0° bevel setting.
If ReAlIGNMeNt IS Needed:
• Adjust the s aw to 0° bevel.
• Retract blade guard (8).
• Loosen bevel adjustment knob (10). Place a square against
the blade (7) and shoe (5) to adjust the 90° setting.
• Loosen jam nut (18a) and move the adjustment screw
(18b) (inset figure j) so that the shoe will stop at the
proper angle. Retighten jam nut against the shoe while
holding adjustment screw in position.
• Confirm the accuracy of the setting by checking the squareness of an actual cut on a
scrap piece of material.
f
G
H
I
j
11
11
5
14
16
15
18b
10
5
17
18a