Intended Use - Porter Cable PCC670 Manual De Instrucciones

This product uses the batteries and chargers listed below.
20V Max* Lithium-Ion Batteries: PCC680L, PCC685L, PCC681L
20V Max* Lithium-Ion Chargers: PCC690L, PCC691L, PCC695L
oPeRAtING INStRuctIoNS

INteNded uSe

This circular saw is design for do-it-yourself, wood-cutting applications.
WARNING:
Do not cut any metals, masonry, glass, tile or plastic with this saw. A dull
blade will cause slow, inefficient cutting overload on the saw motor, excessive splintering,
and could increase the possibility of kickback.
• DO NOT use any abrasive wheels.
• Use only blades designed for wood cutting
• DO NOT use under wet conditions or in the presence of flammable liquids or gases.
• DO NOT let children come in contact with the tool.
• Supervision is required when inexperienced users operate the tool.
WARNING:
Cutting sap coated wood, and other materials may cause melted
substances to accumulate on the blade tips and the body of the saw blade, increasing the
risk of the blade overheating and binding while cutting.
ASSeMBly/AdjuStMeNt Set-uP
WARNING:
to Reduce tHe RISk of INjuRy
SAW BefoRe ANy of tHe folloWING AdjuStMeNt
oPeRAtIoNS.
INStAllING ANd ReMovING tHe
BAtteRy PAck fRoM tHe tool
WARNING:
Make certain the lock-off button is
engaged to prevent switch actuation before
removing or installing battery.
to INStAll BAtteRy PAck: Insert battery pack
into tool as shown in figure B. Ensure battery pack is
fully seated and fully latched into position.
to ReMove BAtteRy PAck: Depress the battery
release button as shown in figure c and pull battery
pack out of tool.
SuPPoRtING lARGe PANelS /
SecuRING WoRkPIece
Support large panels to minimize the risk of blade
pinching and kickback. Large panels tend to sag
under their own weight as shown in figure d.
Supports must be placed under the panel on both
sides, near the line of cut and near the edge of the
panel (figure e).
,
AlWAyS ReMove BAtteRy fRoM
B
c
d
Material bends on blade causing
e
10
Wrong
heavy loads or kickback
Support work near cut