Menu Structure Of Setup; Data Logging - Mettler Toledo SevenGo Duo pro SG78 Instrucciones De Manejo

Setup
5 Setup

5.1 Menu structure of setup

The individual items of the menu setup are described on the pages following the list below.
1.
2.
3.
5.2 Sample ID
An alphanumeric sample ID with up to 12 characters can be entered. Alternatively, a previously entered
sam ple ID can be selected from the list. If a sample ID has been entered, which is either purely numer-
ic (for example, 123) or ends with a number (for example, WATER123), the following options are avail-
able:
1. <Auto Sequential> On
Using this setting will automatically increment the sample ID by 1 for each reading.
2. <Auto Sequential> Off
The sample ID is not incremented automatically.
A maximum of 5 sample IDs are stored in memory and listed for selection. If the maximum of 5 has al-
ready been entered, a sample ID can either be deleted manually or the oldest ID will be automatically
over writ ten by the new ID.
5.3 User ID
A user ID with up to 8 characters can be entered. Alternatively, a previously entered user ID can be
select ed from the list.
A maximum of 5 user IDs are stored in memory and listed for selection. If the maximum of 5 has already
been entered, a user ID can either be deleted manually or the oldest ID will be automatically overwritten
by the new ID.

5.4 Data logging

The meter stores up to 500 sets of measurement data in the memory. The number of data sets already
stored in the memory is indicated by MXXX on the display. A message appears on the display when the
mem o ry is full. To save further measurements if the memory is full, data has to be deleted first. When
mea sur ing in dual channel mode, both results will be stored separately. Therefore, the memory num-
ber in this case will increase by 2. You can select between automatic and manual storage or you can log
your data into the memory in a user-defined interval:
1. Automatic storage
Stores every endpointed reading to the memory automatically.
16
Sample ID
1. Enter Sample ID
2. Select Sample ID
3. Delete Sample ID
User ID
1. Enter User ID
2. Select User ID
3. Delete User ID
Data Logging
1. Automatic Storage
2. Manual Storage
3. Timed Interval Readings
Continue at top of table
4. Data Transfer Settings
1. Interface
2. Printout Format
5. System settings
1. Language
2. Time and Date
3. Access Control
4. Acoustic Signal
5. Routine/Expert Mode
6. Screen Settings
1. Screen Contrast
2. Auto-Shutoff
3. Backlight Off
6. Instrument Self-test
pH/ORP/Ion/Conductivity meter SG78