Operating the refrigerator
7.10
Operation at low outside temperatures
!
CAUTION!
Do not assemble the upper winter cover during gas operation.
I
NOTE
Cold air can affect the performance of the cooling unit.
Assemble the winter covers if you detect a drop in cooling
capacity at low outside temperatures. They will protect the
cooling unit from air that is too cold and could otherwise affect
the performance of the cooling unit.
Assemble the winter covers if the vehicle is going to be
cleaned from the outside or decommissioned for a longer
period of time.
➤ Check regularly that the ventilation grilles (fig. f 1, page 6) and exhaust
gas routing (fig. f 2, page 6) are free from leaves, snow etc.
➤ Mount the winter covers on both ventilation grilles (fig. f 3, page 6).
7.11
Replacing the lighting
➤ Switch off the refrigerator.
➤ Release and remove the LED housing (fig. g, page 6).
➤ Remove the reflector disk.
➤ Connect the new LED lighting (fig. h, page 6). Make sure that the
polarity is correct:
➤ Put the reflector disk back in.
➤ Put the LED housing back in (fig. i, page 6).
➤ Switch on the refrigerator again.
7.12
Replacing the battery on the ignition
➤ Use a screwdriver to turn the cap of the battery ignition (fig. j 1, page 7)
90° to the left.
➤ Pull out the cap and remove the battery (fig. k 1, page 7).
➤ Put in the new battery (type AAA). Make sure the polarity is correct.
➤ Put the cap back in.
98
RM5310, RM5330, RM5380
EN