A Group - Advanced Function Parameters - Reliance electric SP120 Manual De Instrucciones Y Operación

3.2.3 A Group – Advanced Function Parameters
Parameter
Number
Basic Functions
A01 Frequency Command Select
Selects the source of the frequency command for the
drive. Note: If any preset frequency inputs are active, all
other frequency commands will be ignored.
Settings: 00=Frequency pot
01=Input O/OI (Analog reference)
02=Internal frequency (F01 [
A02 Start Command Select
Selects the source of the start command.
Settings: 01=Control terminal block 02=Start Key (Input from Start Key on drive
A03 Base Frequency
Set value to rated nameplate frequency of motor
Voltage
100%
0
Start
Frequency
b82
A04 Maximum Frequency
Highest frequency the drive will output.
Note: If a maximum frequency less than A03 [
FREQUENCY
]. Refer to diagram in A03 [
LIMIT
Analog input reference adjustment
A11 Analog Frequency Minimum
Sets the frequency that corresponds to a 0V or 4mA
analog signal.
A12 Analog Frequency Maximum
Sets the frequency that corresponds to a 10V or 20mA
analog signal. A value of 0.0 will disable this function.
Refer to diagram in A11 [
Parameters and Programming
Tunable parameters are indicated with an asterisk ( * ) preceding the parameter
number.
Parameter Name/ Description
]/ A20 [
COMMAND INTERNAL FREQUENCY
keypad)
Command
Frequency
Frequency
Base Maximum
Frequency
Frequency
A03
A04
] is needed, use A61 [
UPPER FREQUENCY
BASE FREQUENCY
Frequency
A12
A11
0V A13 A14
4mA
ANALOG FREQUENCY MINIMUM
Min./Max
00 to 02
FREQUENCY
])
01 to 02
50 to 360
Upper
Frequency Limit
A61
Hz
Minimum
Frequency
A62
50 to 360
BASE
].
0.0 to 360.0 0.1 Hz
% Input
Scale
10V
20mA
0.0 to 360.0 0.1 Hz
].
Range Units
Numeric
Value
Numeric
Value
1 Hz
1Hz
English
Factory
Default
01
01
60
60
0.0
0.0
3-9