Mounting The Drive; Terminal Block Locations; Figure 2.2 - Terminal Block Locations - Reliance electric SP120 Manual De Instrucciones Y Operación

English

2.2 Mounting the Drive

2.3 Terminal Block Locations

L 5 4 3
H O 0I L FM CM2 12 11
Control terminal block
Control Terminal Block
2-2
Mount the drive on a flat, vertical, and level surface. The drive must be mounted
vertically (top up) for proper heat dissipation. Refer to Appendix A for drive mounting
dimensions.
Install the drive with four (4) M4 x .07 (8-32) screws. Torque the mounting screws to
1.2 Nm (11 lb/in).
Ensure that debris cover is in place when installing the drive to prevent filings, cable
insulation and dust from entering the drive.
Figure 2.2 shows the locations of the power, control, and fault relay terminal blocks.
2 1 P24
Figure 2.2 – Terminal Block Locations
–
+
+1 -
* *
* * *
*
L1 L2 N/L3 U/T1 V/T2 W/T3
S12-201P4LU / 202P6LU / 203P0LU Power terminal block, AA01 - AA03 ratings only
– –
+1 + -
(/)
L2
L1 N/L3 U/T1 V/T2 W/T3
All other model numbers
Power terminal block, all ratings except AA01 -AA03
S12-20015LU only - L1, L2, L3
* Not Used
Power Terminal Block
AL1 AL2
AL0
*
Not used
Fault relay
Fault Relay
terminal block
Terminal Block
SP120 AC Drive Installation and Operation