Wire Wheel Assembly - Bosch GWS10-45 Instrucciones De Funcionamiento

2610041357 09-15 GWS10 GWS13.qxp_GWS series 9/18/15 12:56 PM Page 19
6. Screw in side handle to secure stability
bracket between the tool housing and
handle.
7. Adjust guard to desired depth of cut.
TO REMOVE: Reverse procedure.
Installing dry diamond wheel (Fig. 15):
1. Place the backing flange on the spindle.
Turn flange until it locks with the base of the
spindle.
2. Place the dry diamond wheel onto the
spindle and align the arbor hole of the
grinding wheel with the shoulder of the
backing flange.
3. Tighten lock nut with supplied lock nut
wrench while holding spindle lock.
TO REMOVE: Reverse procedure.

Wire Wheel Assembly

To install wire wheel (Fig. 16):
1. Unplug tool from power source.
2. Install and adjust type 27 grinding guard to
the proper position as shown in figure 5.
3. Thread wire wheel onto spindle until
secure.
NOTE: Be sure to seat wire wheel against
shoulder before turning tool "ON".
TO REMOVE: Reverse procedure.
BACKING
FLANGE
DRY
DIAMOND
WHEEL
FIG. 16
SPINDLE
-19-
FIG. 15
SPINDLE
DRY
DIAMOND
WHEEL
LOCK
NUT
SPINDLE
BACKING
FLANGE
LOCK NUT
TYPE 27
WHEEL GUARD
WIRE WHEEL