Yamaha YSP-1 Manual De Instrucciones página 59

Problem
Surround sound
The listening room is not a regular shape.
effects are
insubstantial.
There is no wall in the path of the beam.
Dolby Digital or DTS The connected component is not set to
sources cannot be output Dolby Digital or DTS digital
played. (Dolby Digital signals.
or DTS indicator in
The input mode is set to ANALOG.
the front panel
display does not light
up.)
Low frequency CROSS OVER in SUBWOOFER SET is
sounds are distorted. set incorrectly.
On-screen display The OSD video cable is not connected
does not appear. properly.
TV is not selected as the input source.
No picture is
The video cable is not connected properly.
displayed for external
TV is not selected as the input source.
components, such as
a DVD player.
This unit does not
The internal microcomputer has been
operate properly. frozen by an external electric shock (such
as lightning or excessive static electricity)
or by a power supply with low voltage.
There is noise This unit is too close to the digital or high-
interference from
frequency equipment.
digital or high-
frequency equipment.
This unit does not The original source includes surround
output effect sounds
effects.
properly.
Cause
Install this unit in a square or rectangular shaped
room.
Place a flat object, such as a board, in the path of the
beam.
Make an appropriate setting following the operating
instructions for your component.
Set the input mode to AUTO.
Set CROSS OVER correctly.
Connect the cable properly.
Select TV as the input source.
Connect the cable properly.
Select TV as the input source.
Disconnect the AC power cable from the outlet and
then plug it in again after about 30 seconds.
Move this unit further away from such equipment.
Disable surround effect settings on this unit.
TROUBLESHOOTING
Remedy
Refer to
page
—
—
—
47
38
12
31
11
31
—
—
—
55