6.6. PEEL COUNTER FUNCTION
The machine has an automatic system for warning when the peel collection bin is full. If you want to
activate this function, please proceed as follows:
• Turn off the machine's power switch.
• With the machine off, press SELECT, and continue pressing while turning the power switch
back on. Keep pressing for four seconds until you see the containers/chutes appear on the
display panel alongside a three-digit figure.
• Once this screen appears you need to enter the number of peels the machine needs to produce
before the alarm goes off. By pressing SELECT intermittently, the number of peels will continue
to increase. If, on the other hand, you press SELECT continuously for more than two seconds,
the number will start reducing.
• Once the number of peels has been selected, press STOP and that quantity will be held in the
machine's memory.
• Once the machine reaches the desired quantity it will stop and the containers/chutes on the
display panel will blink. To continue juicing, the peel deposit must be emptied and then the ON
button pressed in order to reset the counter
TO DEACTIVATE THE PEEL COUNTER.
Repeat the previous operation and set the counter to zero.
6.7. STAND BY
The machine has a stand-by power-saving system which is activated automatically after 5 minutes.
When the machine is on Stand-By, the display light goes out and all the icons except the one for the
machine are disabled.
To exit this situation, press any of the three buttons on the plate.
To deactivate the Stand By, repeat the 6.4. section process by entering the code 8024.
To activate, repeat the process by entering the code 8023.
6.8. CLEANING
The machine squeezing area and parts must be cleaned daily*.
* For an use with pomegranates, it is recommended to clean this zone every 30 Kg of squeezed fruit.
•
If the machine is in operation, stop it always using the Programmer button Stop. Never attempt to
stop the machine using the main switch. Failure to follow this recommendation will cause the
machine to stop in a position that impedes cleaning; possibly leading to breakage of parts due to
poor handling.
•
Disconnect the machine turning the power switch off (Fig. 6). Then the digital display will turn off.
•
Remove the Front Cover and wash it using a damp cloth. (ATTENTION! NEVER use products that
may scratch it).
31