Tecno-gaz Europa B xp Instrucciones De Uso página 51

FIGURE 1
Back view 1.3
Pos. 6
14 - Turn on the autoclave by pushing the general switch (fig.2 pos.16) and open the door to the autoclave.
Wait a few seconds, there will be two beeps which indicate the reaching of relative parameters for automatic
atmospheric alignment, at the same time the display will indicate "door open".
IMPORTANT
Never select a command before the two beeps, in that the autoclave will not accept the chosen
program.
FIGURE 2
Frontal view 1.1
Pos. 16
15 – Load the pure water tank following the indications in the section entitled USAGE INSTRUCTIONS.
Successively run the test cycle, always following the indications expressed in the section USAGE
INSTRUCTIONS.
16 – If the autoclave is installed with a system of deionization mod. WATERCLEAN, comply with instructions
contained in the package of this device.
51 DXBA408 Rev_14