Toshiba MMU-AP0071MH Manual Del Propietário página 14

Based on the shape or arrangement of the room, the cold air and hot air can be discharged in two directions or
three directions. For details, please contact your local dealer.
• If cooling operation is performed with a downwards discharge, dew may form on the surface of the
cabinet or the horizontal flap resulting in dripping.
• If heating operation is performed with a horizontal discharge, the room temperature may not be equal i.e.
there may be a large variance between one side of the room with the other.
• Do not move the horizontal flap directly with your hands; otherwise a fault maybe caused. Select the
direction of the horizontal flap using the flap operation switch on the remote controller. The horizontal flap
will not stop immediately, even if the switch is pushed.
Note) Pushing the switch again when the required louver direction has been reached will stop the louver.
2-way Air Discharge Cassette Type
[In Cooling operation]
Use the air outlet flap with a horizontal set point.
[In Heating operation (For Heat-pump model only)]
Use the air outlet flap with a downwards set point.
Setup of air flow direction and swinging function
1
SWING/FIX
Push the button during operation.
• [SWING ] is displayed and the air flow direction will automatically change either upwards/downwards.
In the case of one remote controller that controls multiple indoor units, each indoor unit can be selected
and its air flow direction can be adjusted.
2
SWING/FIX
Push the button again during the swinging
of the air outlet flap.
• The air outlet flap will be stopped at the desired position.
3
UNIT
• To set up the air flow direction individually, push the
UNIT
button to display each indoor unit No. in a group
control. You can then set the air flow direction for the
displayed indoor unit.
• If there is no display, all the indoor units can be oper-
ated collectively.
• For every push of the
between units, as shown in the figure.
1-way Air Discharge Cassette Type
Adjustment of air flow direction upwards/downwards
[In Cooling operation]
In cooling operation, use the air outlet flap with a horizontal set point
so that the cold air diffuses the whole room.
[In Heating operation (For Heat-pump model only)]
In heating operation, use the air outlet flap with a downwards set
point so that the hot air is directed towards the floor.
Adjustment of air flow direction rightwards/leftwards
To change the discharge direction to right or left side, set the verti-
cal grille inside of the air outlet flap to the desired direction.
Setup the air flow direction and swinging function
Refer to the description of the "2-way Air Discharge Cassette Type".
INFORMATION
UNIT
button, the display alters
11
TEMP.
TIMER SET FAN
TIME SWING/FIX
FILTER
RESET TEST SET CL UNIT
1, 2
No display Unit No. 1-1
Unit No. 1-4 Unit No. 1-3
ON / OFF
MODE
VENT
3
Unit No. 1-2