General Instructions; Important; Intended Purpose Of The Manual; Manufacturer And Machine Identification - Virutex EB140 Manual De Instrucciones

1. GENERAL INSTRUCTIONS

IMPORTANT

Before using this machine, read this INSTRUCTION MA-
NUAL carefully. Make sure you have understood it before
operating the machine. Keep the instruction manual for
future reference.

1.1 INTENDED PURPOSE OF THE MANUAL

This manual has been written by the manufacturer and
forms an essential part of the machine. The information
contained in it is intended for experienced, trained te-
chnical personnel who are aware of the pertinent laws
and regulations. Personnel must be able to recognise and
prevent possible hazards, both when handling the ma-
chine and during its installation, adjustment and main-
tenance operations.
This manual contains all the information necessary to en-
sure the safe, correct use of this machine.
A
B
C D
H I
(Figure 0)
66 - EB140 / Operating instructions
E F G
J K
It has been divided into sections, listed in the table of
contents, so that information will be easier to locate.
The most important information appears in bold type un-
der the titles:
WARNING:
This indicates hazards that might cause se-
rious injuries to the operator if the steps
described are not strictly followed.
CAUTION:
This indicates hazards that may cause dama-
ge to property or to the machine itself.
1.2 MANUFACTURER AND MACHINE
IDENTIFICATION
The identification plate (Fig. 0), is located on the back of
the machine. It contains the following information:
A – Manufacturer's identification
B – Machine model
C – Rated voltage
D – Electrical frequency in Hz
E – Power input in kW
F – Rated current in Amperes
G – Feeder speed in m/min
H – Number of phases
I – Weight in kg
J – Serial number
K – Year of manufacture
It is necessary to specify the machine information or its
manufacturing number when requesting replacement
parts or any clarification regarding its operation.

1.3 TECHNICAL ASSISTANCE

It is not recommended to repair the machine or to per-
form any operation not described in this manual. Only
authorised technical personnel may perform repairs and
readjustments of parts and machine safety devices.