Thermal Fuses; Anti-Tipping; Changing The Battery; Maintenance - Vermeiren Carpo 2 Manual De Instrucciones

3.9

Thermal fuses

The thermal safety device can go loose if you go up or down slopes that exceed the maximum
gradient indicated. Nominal loads that exceed the maximum permitted could also cause the device to
jump out. Likewise, if you keep on driving with the engine brake on, it could result in overload. The
maximum values not to exceed are indicated in the chapter "Technical Specifications" of the
corresponding manual.
To be able to use the scooter again, remove the overload and wait till the motor has cooled off. Then
gently press the thermal safety mechanism back in. Your scooter is now ready for use again.

3.10 Anti-tipping

3.11 Changing the battery

L
CAUTION: Risk of burns - Do not come in contact with the acid from the batteries. See for
a good ventilation of the battery compartment.
The battery shall be changed by trained personel.
The wiring and charger are well situated in the scooter. Do not attempt to re-locate the wiring by
yourself. The improper installation of the wiring may result in pinching the wiring between the battery
box, which cause failure to the electronic system of your scooter.
Be sure the battery cables are connected to the right battery.
4

Maintenance

For the maintenance manual of the scooters refer to the Vermeiren website: www.vermeiren.be.
To protect the motor against overload, your
scooter have a thermal safety mechanism 
on the rear of your scooter. The thermal fuse
will automatically cut the motor to prevent
overheating and thus rapid wear and tear or
breakdowns. You can access the thermal
safety device through a gap in the back of
the synthetic cover.
An anti-tipping  is fixed to the frame of the
scooter on the back side. It is not possible to
remove these. The anti-tipping is there for
your safety. It prevents the scooter from
tipping over backward when you drive over
small obstacles that do NOT exceed the
maximum height specified.
Page 26
Carpo 2
2015-07