Assembly And Disassembly Of The Scooter - Vermeiren Carpo 2 Manual De Instrucciones

If this is not possible you can carry the scooter by following steps:
1. Switch the scooter off.
2. Remove loose parts (seat and batteries).
3. Store loose parts in a safe place.
4. Carry the frame + steering unit with 2 or 3 persons to the desired place. Take the frame on the
chassis, and not by the bumpers or the plastic parts. Only on the fixed parts from the frame.
2.3

Assembly and disassembly of the scooter

L
WARNING:
Risk of injury - Make sure that all movable parts are assembled properly.
L
WARNING:
Risk of injury - Assembly and disassembly must be done by trained
personnel (e.g. specialist dealer).
L
WARNING:
Risk of injury - Be careful not to cut or bruise yourself with the cables.
L
WARNING:
Risk of injury - Turn the scooter off before disassembly.
L
CAUTION:
Risk of pinching - Do not place fingers between the components of the
scooter.
To disassemble, please proceed as follows:

Switch the scooter off.

Remove the seat (see "Adjusting the seat" chapter).

Lift off the rear plastic cover of the batteries.
To reassemble, please proceed as follows:

Loosen the straps used to fasten the
batteries in place.

Unplug all battery plugs (not the pole
connectors) and all cable plug- and socket
connections.

Lift the batteries out.

Fold the steering unit down.

Move the steering unit upwards.

Put the batteries back in and connect to
the battery plugs (plugs of the same color
go together).

Use the straps to tighten the batteries in
such a way that they will not move, even
during drives.

Mount the rear plastic cover.

Mount the seat (see "Adjusting the seat"
chapter).
Page 10
Carpo 2
2015-07