Warranty Disclaimer - Hama EWS-3300 Instrucciones De Uso

• The weather station indicates a trend as to how the values
for the outdoor temperature (14), room temperature (10) and
atmospheric pressure (7)) are likely to develop over the next
few hours.
Display
6.4. Maximum and minimum temperature values
The base station automatically stores the maximum and minimum
outdoor/indoor temperature.
• Repeatedly press the mem button (16) to switch between the
current temperature, minimum temperature (MIN) and maximum
temperature (MAX).
• Press and hold the mem button (16) for approx. 3 seconds to
reset the stored maximum and minimum values.
6.5. Outdoor temperature alarm
• In temperature mode, repeatedly press the alarm button (15) to
display the outdoor temperature alarms
• Press and hold the alarm button (15) for approx. 3 seconds until
the outdoor temperature display (14) begins to flash.
• Press the button (18) or the
displayed limit value and confirm your selection by pressing the
alarm button (15).
• While the upper or lower
press the button (18) or the
temperature value or OFF and then press the alarm button (15)
to confirm the selection.
Select the temperature value/OFF to activate/deactivate the
outdoor temperature alarm.
• The alarm is triggered accordingly if the outdoor temperature
reaches one of these limit values.
The symbol and the outdoor temperature start to flash and an
alarm signal sounds.
Press the alarm button (15) to stop the alarm. Otherwise, it will
stop automatically after 2 minutes.
Trend
Increasing
Constant
Decreasing
/ .
button (19) to set the
limit values are displayed,
button (19) to select the
Note – Outdoor temperature alarm
• Note that the lower limit value must be at least 1°C/1°F
below the upper limit value.
6.6. Low battery capacity
As soon as the battery symbol
station, the capacity of the batteries in the base/measuring station
is very low. Replace the batteries immediately.
Note – Replacing the batteries
• Note that the stations have to be resynchronised each
time after you change the batteries in the measuring or
base station.
• To do this, remove the batteries from the other station and
then reinsert them, or change them as required.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do
not use aggressive cleaning agents.

8. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/mounting,
improper use of the product or from failure to observe the operating
instructions and/or safety notes.
9. Service and Support
Please contact Hama Product Consulting if you have any questions
about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com
appears on the display of the base
7