Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3
Inspection - Description of the machine
• On receiving the machine check its condition.
• Always keep it perfectly clean
• Check the supply cable and the extension lead
periodically
• Always keep alert when working
• Check that the parts are properly fixed (no
abnormal vibration) and that it is correctly
assembled.
1
FIG.
Chassis
1
Leg
2
Leg locking knob
3
Water pump
4
locking Clip
5
90° to 45° locking knob
6
19 mm spanner
7
Drain plug
8
Motor
9
Lack of voltage switch
10
Operating handle
11
Disc casing
12
Rail
13
Plate
14
Plate stops
15
Head carriage
16
Manufacturer's plate
17
Cutting plate
18
Plate side extension
19
Tank
20
4
Transport
•
Lock the head on the rear part of the machine
using clip
(A) - [
SEE FIG.
•
Loosen the two flywheels
swivel them, then retighten the flywheels
[
3].
SEE FIG.
• Repeat the same procedure for the back legs.
• To reinstall the machine on its legs, carry out the
same procedure in reverse.
For these different operations
always disconnect the machine
2]
(B) of the front legs,
(B) -
5
Check before starting
Please read the instructions for use
prior to operating the machine for
the first time.
Motor off.
The
working
completely cleared, well lit and all
safety hazards removed (no water
or dangerous objects in the vicinity)
The
operator
protective clothing appropriate
to the work he is doing. We
recommend that this includes
both eye and ear protection
The use of ear protection is
mandatory.
Any persons not involved in the
work should leave the working area
Use only blades marked with a
maximum operating speed greater
than blade shaft speed
6
Fitting the disc
Disconnect the machine by unplugging
the supply cable.
• Release the two knobs
remove them and then remove the guard.
• Unscrew the disk clamping nut
using a 19 mm spanner.
The disc locking nut has a left-hand
thread.
• Remove the clamping plate
Take care about the direction of
rotation which is shown by an arrow
on one of the faces.
Make sure the contact faces of
flanges, of blade and the axle are
clean.
• Check the disk position on the centring plate
- [
6]
SEE FIG.
•
Refit the clamping plate
(D).
• Replace the guard, tighten the knobs
area
must
be
must
wear
(C) - [
4],
SEE FIG.
(D)- [
5]
SEE FIG.
(E) and fit the disk.
(F)
(E) and tighten the nut
(C).
21
Tabla de contenido
