Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7
Electrical connection
-
ELECTRICAL SAFETY :
Operate this machine only on a
supply equipped with a 30 mA
earthed current-limiting circuit-
breaker. Otherwise, consult our
catalogue for appropriate models.
- The RCCB must be used correctly,
including testing it regularly. For
tools supplied with an integral
RCCB in the cable or in the mains
plug, if the cable or plug has been
damaged, repairs must be carried
out by the manufacturer, one of
his agents or by a qualified repair
workshop to avoid any risks
resulting from errors.
• Engines :
* Standard : with on-off switch with no-volt
release switch
- 1-phase, 230 V, 1000 W (1,3 hp)
3 x 1.5 mm
*
Optional : with cut-out switch with or without
ammeter
- 1-phase, 110 V, 1000 W (1,3 hp)
3 x 2.5 mm
-
Make sure that the mains voltage
corresponds with that marked on the
manufacturer's plate on the machine.
- Use the following types of plug, single
phase 2 P + E
2 P + E
230 V
H07 - RNF
H07 - RNF
3 x 2,5
2
+ (x2)
50 M
100 M
- Extension lead : Cable size sufficient for the
electrical power, connection to the mains by a
H07 RNF type cable of the following size :
- 3 x 2.5 mm
- 3 x 4 mm
2
22
with plug (cable 2 P + E)
2
2
without plug (cable 2 P + E)
400 V
115 V
H07 - RNF
4 ou 5x1,5
2
3 x 4
2
+ (x2)
+ (x2)
40 M
2
up to 50 m for 230 V
up to 40 m for 115 V
8
Starting up
Always take care.
Get into a comfortable, balanced
position.
Remove all adjustment tools and
wrenches from floor and machine
Always keep blade guard in place
•
For wet cutting:
* Fill the clean water tank to maximum capacity.
* Immerse pump in tank.
Ensure that the water supply is abundant,
when cutting wet.
•
To start the machine press the green
button on the switch (optional cut-out
switch).
•
To stop the machine, press the red
button.
As each saw is fitted with a self-
priming pump, the disk is sprayed as
soon as the saw is turned on.
The protective guard and the motor
mounting ensure that the disk is
sprayed evenly.
9
Cutting method
•
Square cuts :
*
Remove the disk support head towards the
rear.
* Position the material on the table.
* Pull the head towards yourself whilst gradually
forward it without forcing the blade (avoid
sudden contact with the material).
•
45 degree bevel cuts :
*
Loosen the two adjusting flywheels
7].
FIG.
*
Tip over the cutting head and rail assembly.
* Relock the flywheels.
•
With the head down (for foils, mouldings, etc.) :
* Unscrew the locking lever
*
Adjust to the required cutting depth
[
]
SEE FIG.8
*
Relock the wedge-shaped screw
* Proceed to cut.
(G)
[
SEE
(J).
(J).
Tabla de contenido
