Husqvarna FS 3500 G Manual De Instrucciones página 23

Water safety system
Water is used to prevent overheating the blade while
controlling the dust that results from sawing. The water safety
system monitors the water pressure to the machine and
interrupts the sawing process if the pressure drops.
• Set the Forward/Reverse control lever to the Stop/Neutral
position. The engine will not start unless the lever is in the
distinct Stop/Neutral position.
• Start the engine.
• Let the engine warm up for several minutes with Engine
throttle at idle speed (minimum).
Do not warm up the machine outside the cutting area, when
the blade is fitted to the machine. To fit the blade, see the
instructions under the heading Fitting the blade.
Start the cutting
WARNING! Never use a blade with a lower
speed rating than that of the machine. Make
sure the blade is properly installed.
NOTICE! See chart for the appropriate blade shaft and
engine speeds for specific blade sizes.
• Test for adequate water supply. Low water flow will cause
damage to diamond blades. Engage the Water safety
switch on the control panel and open the Water valve.
STARTING AND STOPPING
• Shift the Forward/Reverse control lever into gear.
• Set the Engine throttle knob to maximum rpm.
• Lower the blade by pressing the Raise/Lower switch on
the Forward/Reverse control lever until the blade is at the
desired cutting depth. For more information see section
"Blade cutting depth".
CAUTION! When lowering the blade into a partial cut, align
the blade exactly with the cut to prevent damage to the
blade.
• Move the saw forward slowly by pushing on the Forward/
Reverse control lever. Listen to the sound of the engine. If
the engine starts to slow down compensate by pulling
Forward/Reverse control lever backwards to decrease
feeding and prevent stalling the blade. Make sure the front
guide, rear guide and diamond blade stays on the line.
– 23
English