To Do A Check Of The Transmission Oil Level - Husqvarna P 520D Manual De Usuario

Ocultar thumbs Ver también para P 520D:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Slowly fill the oil through the dipstick opening.
Technical data on page 44 of engine oil
Note: See
recommended. Do not mix different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
To change the engine oil and the oil
filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine for
more than 1–2 minutes before you drain the
engine oil. The engine oil becomes very hot
and can cause burn injuries. Let the engine
become cool down before you drain the
engine oil.
WARNING: If you spill engine oil on your
body, clean with soap and water.
1. Put a container below the oil drain plug on the left
side of the engine.
2. Remove the oil drain plug.
3. Remove the dipstick.
4. Drain the oil into the container.
5. Attach the oil drain plug and tighten it.
36
6. Turn the oil filter counterclockwise to remove it.
7. Lightly lubricate the rubber seal on the new oil filter
with new oil.
8. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
9. Fill with new oil as given in
44 .
10. Start the engine and let it run at idle speed speed for
3 minutes.
11. Stop the engine and make sure that the oil filter does
not leak.
12. Do a check of the oil level.
Note: For safe disposal of used engine oil, see
on page 43 .
To do a check of the transmission
oil level
1. Use the oil dipstick to read the oil level in the
transmission.
2. The oil level must be between the marks on the
dipstick.
3. If the oil level is too low, fill with the type of oil given
Technical data on page 44 .
in
Technical data on page
Disposal
740 - 004 -
Tabla de contenido
loading

Este manual también es adecuado para:

P 525dP 525d with cabin

Tabla de contenido