To Lubricate The Belt Adjuster; To Do A Check Of The Transmission Oil Level - Husqvarna R 318X Manual De Usuario

9. Turn the oil filter counterclockwise to remove it.
10. Lightly lubricate the rubber seal on the new oil filter
with new oil.
11. To attach the oil filter, turn it clockwise by hand until
the rubber seal is in position, then tighten a half turn
more.
12. Fill with new oil as given in
33 .
13. Start the engine and let it idle for 3 minutes.
14. Stop the engine and make sure that the oil filter does
not leak.
15. Fill with oil to compensate for the oil held in the new
oil filter.
Note: For safe disposal of used engine oil, see
on page 32 .
To do a check of the transmission oil
level
1. Remove the two screws, one on each side, and lift
off the transmission cover.
838 - 005 - 21.10.2019
Technical data on page
Disposal
2. Make sure that the oil level in the transmission oil
tank is between the two horizontal lines on the tank.
3. Fill with engine oil if the oil level is below the lower
line, but do not fill above the top line.
Technical data on page 33 for
Note: See
recommended oil for R 318X and R 320X AWD. R
320X AWD must have a synthetic oil.

To lubricate the belt adjuster

The belt adjuster must be lubricated regularly with a
good quality molybdenum disulphide grease.
1. Remove the 2 screws that hold the belt shield and lift
it off.
2. Lubricate with a grease gun through the nipple at the
right side, below the lower belt pulley. Lubricate until
grease is pushed out of the rear side of the nipple.
3. Attach the belt shield and tighten the 2 screws.
27