Using Auto Setup (Intellibeam) - Yamaha YSP-5600 Manual De Instrucciones

1 2 3 4

Using AUTO SETUP (IntelliBeam)

• Test tones output during measurement are loud. Perform AUTO SETUP when no children are around and
there is no possibility of their entering the listening room, as their hearing may be impaired.
• If there are curtains in your listening room, we recommend following the procedure below.
1. Open the curtains to improve sound reflection.
2. Run "Beam optimize only" (page 33 in the Owner's Manual).
3. Close the curtains.
4. Run "Sound optimize only" (page 33 in the Owner's Manual).
• Make sure that your listening room is as quiet as possible. For accurate measurement, turn off air
conditioner or other devices that make noises.
1
Turn the unit and your TV on.
• When a subwoofer is connected to the unit, turn on the subwoofer, and set the volume and crossover
frequency as shown below.
Set the volume to half
VOLUME
MIN MAX
2
Switch TV input to display video input from this unit (page 28 in the
Owner's Manual).
Set the crossover frequency to maximum
CROSSOVER
HIGH CUT
MIN MAX
3
Connect the IntelliBeam microphone to the INTELLIBEAM MIC jack
of the unit.
INTELLIBEAM MIC INTELLIBEAM MIC
IntelliBeam microphone
The screen below is displayed after connecting IntelliBeam microphone to the
unit.
( P R E P A R A T I O N
P l e a s e c o n n e c t
P l e a s e p l a c e
1 . 8 m / 6 f t
j e c t o r . T h e
a t e a r l e v e l
M e a s u r e m e n t
A f t e r [ E N T E R ]
p l e a s e l e a v e
[ E N T E R ] : S t a r t
"AUTO SETUP" in the "IntelliBeam" menu can automatically adjust the
following two settings.
This feature optimizes the beam angle so that the parameter best
Beam optimize only
matches your listening environment.
This feature optimizes sound quality for each channel by
Sound optimize only measuring the acoustic characteristics of the listening
environment.
"Beam optimize only" or "Sound optimize only" can be measured separately in
the setup menu (page 33 in the Owner's Manual).
• Follow the instructions below and then leave the room. If you remain in the room, you may obstruct
the beam, or the microphone may pickup any sounds you make, possibly resulting in improper
measurement.
c Auto setup for appropriate surround effects (IntelliBeam)
Cardboard microphone stand
A U T O S E T U P
& C H E C K )
t h e M I C .
t h e M I C a t l e a s t
a w a y f r o m S o u n d P r o -
M I C s h o u l d b e s e t
w h e n s e a t e d .
t a k e s a b o u t 3 m i n .
i s p r e s s e d ,
t h e r o o m .
[ R E T U R N ] : C a n c e l
13
En