Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Installation of the Cyclone in the Shredder
1. Loosen the body (1) and stand (2), retaining nuts
located under the stand.
2. Fit body wedges (3) between the body (1) and
stand (2), to provide a gap between them and to
allow the closing plate (5) to move. Retighten the
body (1) retaining nuts.
3. Place the belts on the pulley (12).
4. Place exhaust rear closing (7) on the pulley (12).
5. Secure the fan (8) to the pulley (12) using screw
(9) and washer (19) that come with the cyclone
set.
16
20
15
14
6. Secure the exhaust body (10) to the body (1) by
7. Secure exhaust rear closing (7) to the exhaust
8. Screw the rods (15) to the silo (14) legs.
9. Fit exhaust rubber joint (17) to the upper outlet
4
17
13
10
11
19
7
mean of screws (11).
body (10) using screw (6), washer (18) an nut (13).
Simultaneously fit the legs to the silo support (20)
and the rod (15) to the hole at the lower part of
the silo (16). Tighten the rod (15) using the nut on
the inside part of the silo.
of the exhaust assembled (10 and 7). Fit the tube
(4) to the silo (16) and then to the exhaust rubber
joint (17).
9
8
12
6
18
3
1
2
5
45
Tabla de contenido
