Attach Handle - Craftsman 580.752722 Instrucciones De Uso

Your cleaning system requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
if you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
UNPACK THE PRESSURE WASHER
1. Remove everything from carton except pressure
washer.
2. Open carton completely by cutting each corner
from top to bottom.
3. Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
Main Unit
Handle with Cleaning Tanks Assembly
Accessory Tray
Hose Reel Components
High Pressure Hose
Spray Gun
Nozzle Extension with Quick Connect Fitting
HydroFoam
TM
Wash
Oil Bottle
Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Bag containing 3 multi-colored ProjectPro
TM
Nozzles
• HydroFoam
TM
Launcher
• HydroFoam
TM
Launcher & Wash Instruction
Sheet
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly
before operation:
1. Attach handle to main unit.
2. Connect detergent siphon hose to pump.
3. Attach hose reel to handle as shown on page 6
according to instruction sheet included with hose reel.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect nozzle to nozzle
extension.
Attach Handle
1. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
// Handle / j
/
Supports I
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports,
2. Insert carriage bolts through holes from outside of
unit and attach plastic knob from inside of unit,
Tighten by hand,
%.
• Safety Goggles
• Fresh Start Fuel Cartridge
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (4)
Become familiar with each piece before assembling
the pressure washer. Identify all contents with the
illustration on page 6. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
3. Place accessory tray over holes on handle
(viewing from front of unit). Push tree clips into
holes until they sit flat against accessory tray.
4. Insert multi-colored ProjectPro
TM
nozzles and
other supplied accessories in spaces provided in
accessory tray, See "How to Use Accessory Tray",