Tabla de contenido
Idiomas disponibles
Idiomas disponibles
For maximum rinsing (higher pressure and
lower flow), for stubborn or hard to reach
surface such as second story surfaces, paint
removal, oil stains, rust removal or other
stubborn substances (tar, gum, grease, wax,
etc.), select red max ProjectPro
TM
nozzle.
4.
Pull back on collar, insert selected ProjectPro
TM
nozzle and release collar. Tug on ProjectPro
TM
nozzle to make sure it is securely in place.
5.
For most effective cleaning, keep ProjectPro
TM
nozzle from 8 to 24 inches away from cleaning
surface. If you get the nozzle too close, you may
damage the cleaning surface.
6.
DO NOT get closer than 6 inches when cleaning tires.
How to Use the HydroFoam
TM
Launcher
The quick-connect
on the nozzle extension allows you
to attach the HydroFoam
TM
launcher. Use the
HydroFoam
TM
launcher to apply HydroFoam
TM
wash
or other project specific cleaners to help break down
stubborn dirt and grime on a variety of surfaces.
Follow these instructions to attach the HydroFoam
TM
launcher:
1.
Engage trigger lock on spray gun.
2.
Pull back collar on quick-connect
and pull current
ProjectPro
TM
nozzle off. Store ProjectPro
TM
nozzles in holder provided on the accessory tray.
3.
Pull back on collar, insert HyrdoFoam
TM
launcher
and release collar. Tug on HyrdoFoam
TM
launcher
to make sure it is securely in place.
IMPORTANT: Also see the HydroFoam
TM
launcher
and wash instruction sheet for important instructions
and uses.
Cleaning
and Applying
Detergent
IMPORTANT:
Use detergents
designed
specifically
for pressure
washers.
Household detergents could
damage the pump.
CAUTION
Starting
the engine
without
all the hoses
connected
and
without
the water
turned
ON will damage
the pump.
Damage
to equipment
resulting
from failure
to follow
this
instruction
will void warranty.
To apply detergent follow these steps:
1.
Review ProjectPro
TM
nozzle and HydroFoam
TM
launcher use.
2.
Prepare HydroFoam
TM
wash or detergents as
required by manufacturer.
3.
Pour solution into cleaning tank labeled A or B.
NOTE: Each cleaning tank holds two quarts.
4.
Fill other cleaning tank with a different prepared
solution, as desired.
5.
Make sure HyrdoFoam
TM
launcher is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
6.
Make sure garden hose is connected to water inlet
and water supply is turned on. Check that high
pressure hose is connected to spray gun and
pump; start engine.
7.
Rotate detergent shut-off valve on desired
cleaning tank to "On" position.
L_
"Off" Position
L
Only one detergent
solution
should
be used at a time to
avoid possible
bodily
injury and/or
property
damage.
8.
Apply HydroFoam
TM
wash or detergent solution to
a dry surface, starting at lower portion of area to be
washed and work upward, using long, even,
overlapping strokes.
NOTE: To prevent water spotting on vehicles, work in
a shaded area and allow surfaces to cool before
beginning.
13
Tabla de contenido
