Unpack The Pressure Washer; Attach Handle - Craftsman 580.752820 Instrucciones De Uso

Your cleaning system requires some assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
if you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3136.
iMPORTANT: Any attempt to run the engine before it
has been serviced with the recommended oil will result
in an engine failure,
UNPACK THE PRESSURE WASHER
,
2.
3.
Remove everything from carton except pressure
washer.
Open carton completely by cutting each corner
from top to bottom.
Remove pressure washer from carton.
CARTON CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3136.
• Main Unit
• Handle with Cleaning Tanks Assembly
• Accessory Tray
• Hose Reel Components
• High Pressure Hose
• Spray Gun
• Nozzle Extension with Quick Connect Fitting
• HydroFoam
TM
Wash
• Oil Bottle
• Parts Bag (which includes the following):
• Operator's Manual
• Owner's Registration Card
• Safety Goggles
• 2 Sets of Quick Connects for High Pressure
Outlet and Water Inlet
• Bag containing 3 multi-colored ProjectPro
TM
nozzles
• HydroFoam
TM
Launcher
• HydroFoam
TM
Launcher & Wash Instruction Sheet
• Fresh Start
TM
Fuel Cartridge
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the illustration
on page 6. If any parts are missing or damaged, call the
pressure washer helpline at 1-800-222-3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly
before operation:
1. Attach handle to main unit.
2.
Connect detergent siphon hose to pump.
3. Attach hose reel to handle as shown on page 6
according to instruction sheet included with hose reel.
4. Add oil to engine crankcase.
5. Add fuel to fuel tank.
6. Connect high pressure hose to spray gun and pump.
7. Connect water supply to pump.
8. Attach nozzle extension to spray gun.
9. Select/attach quick connect nozzle to nozzle extension.
Attach Handle
,
Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
/ \
_"- /'/ Handle
Align
" Handle
Supports _ _
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from front of
unit and attach plastic knob from back of unit.
Tighten by hand,
3. Place accessory tray over holes on handle
(viewing from front of unit). Push tree clips into
holes until they sit flat against accessory tray.
,
J /
Insert multi-colored ProjectPro
TM
nozzles and
other supplied accessories in spaces provided in
accessory tray. See "How to Use Accessory Tray".