Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2. Pushto"snap" cartridge intoplace.
3. Remove t abtoexpose membrane.
iMPORTANT: DONOTremove thesilverfoilsealon
theopposite side.
4. Reinstall fuelcapon fueltank.
5.
Periodically
check the cartridge
to ensure
there is
still fuel stabilizer inside. If it is empty, remove
cartridge
and replace.
Connect
Hose and Water
Supply
to Pump
iMPORTANT:
To avoid pump damage, you must
assemble the nozzle extension to the spray gun and
attach all hoses before you start the engine.
1.
Uncoil high pressure hose and attach one end of
hose to base of spray gun. Tighten by hand.
NOTE: Remove and discard shipping caps from pump
inlet and outlet,
2.
Attach other end of high pressure hose to high
pressure outlet on pump, Tighten by hand,
Inspect inlet
screen, DO NOT
if damaged;
clean if dirty,
3.
Before connecting garden hose to water inlet,
inspect inlet screen. Clean screen if it contains
debris or have it replaced if damaged. DO NOT
run pressure washer if inlet screen is damaged
or missing.
4.
Run water through garden hose for 30 seconds to
flush it of debris. Turn off water.
iMPORTANT:
DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100°F).
5.
Connect garden hose (not to exceed 50 feet in
length) to water inlet. Tighten by hand.
CAUTION
Damage
to equipment
resulting
from failure
to follow
this
instruction
will void warranty.
6.
Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
impurities.
WARNING
Always
wear
safety
goggles
when using
this equipment
or in vicinity
of where
equipment
is in use.
Before
starting
the pressure
washer,
be sure you are
wearing
adequate
safety
goggles.
CHECKLIST
BEFORE
STARTING
ENGINE
Review the unit to ensure you have performed all of
the following:
1.
Make sure handle is in place and secure.
2.
Check that oil has been added to proper level in
engine crankcase.
3.
Add proper fuel to fuel tank.
4.
Check for proper hose connections (high pressure
and water supply) and that there are no kinks,
cuts, or damage to the high pressure hose.
5.
Provide proper water supply (not to exceed
100°F).
6.
Be sure to read "Safety Rules" and "Operation"
sections before using the cleaning system,
Tabla de contenido
