Edirol UA-3 Manual Del Usuario página 114

Appendices
Recording narration or vocal sounds
Make connections as shown in the following diagram.
Condenser
mic
Set to "INPUT + GUITAR/MIC"
Select a MIC type
according to your mic.
Set the recording sample rate of your recording application to the desired setting. (The available sample rates will de-
pend on your application. For details refer to the owner's manual for your application.) Available sampling frequencies
vary depending on the operating system used.
Use the Guitar/Mic input adjustment slider to adjust the input level. If the LED above the slider lights red, use
the slider to lower the input level.
above the slider lights red, use the slider to lower the input level. You
use the slider to adjust the level so it is as high as you can get it before causing the LED to light.
114
Monitor
speakers
Dynamic
mic
Audio cable
MIC will be output.
LINE
OUT
UA-3
Use the Guitar/Mic input adjustment slider to adjust the input level. If the LED
Computer
LINE IN
USB
port
USB cable
MIC will be recorded
to the computer.
USB
port
Stereo
Headphones
The MIC will be output.
MIC input signal flow
will be able to record with higher audio quality if you
• CONDENSER MIC
The UA-3 supports small multimedia
microphones used for adding narration,
and is compatible with plug-in powered
monaural microphones
• Howling could be produced depending on
the location of microphones relative to
speakers. This can be remedied by: 1.
Changing the orientation of the micro-
phones(s). 2. Relocating microphone(s) at
a greater distance from speakers. 3. Lower-
ing volume levels.
• If you change the position of the Record-
ing input select switch, you should
turn down the volume of any monitor
speaker system that is connected.