Adjusting Seat Depth; Flexible Backrest - Vermeiren Eclips X4 KIDS Manual De Instrucciones

3.6

Adjusting seat depth

L WARNING:
Risk of injury - Make sure that all screws are properly tightened
before using the wheelchair.
The seat depth can be adjusted from 310 mm to 370 mm in steps from 20 mm for seat width
320 mm and from 330 mm to 390 mm in steps from 20 mm for seat width 370 mm.
6. Remove the adjustable axle adapter, if available on your wheelchair.
7. Adjust the seat depth to the desired position by moving the back frame  and/or seat
frame  steps from 20 mm.
8. Tighten all the screws properly by hand.
9. Fold the flap of the backrest under the seat (Velcro fastening), to close the gap between
the back frame and the seat.
10. Adjusting the seat is not necessary.
11. Replace the arm rests (cloth protectors), foot rests and rear wheels. Mount the arm rests
in the correct hole of attachment plate .
3.7

Flexible backrest

L WARNING:
Risk of injury - Make sure that all screws are properly tightened
before using the wheelchair.
1
The height of the backrest can be adjusted by setting the
entire back tube.
For adjusting the height of the back cover, loosen the
fixing screws  behind the back tube. Then you can
move the cover upwards or downwards. There are fixing
holes every 20 mm in the back tube where the screws
can be retightened.
Page 18
Eclips X4 kids
Adjust the seat depth according
following procedure:
1. Remove the arm rests (cloth
protectors), foot rests and
rear wheels.
2. Loosen the screws .
3. Loosen the screws .
4. Remove the crosses from the
seat located on the main
frame  by folding the
wheelchair.
5. Remove the screws 
located in the blocks for the
cross  on the main
frame .
2016-01