Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6 Putting into operation
6.6 Changing the drive rolls
1
6
5
1
2 pressure rockers
2
2 pressure rolls
Fig. 9
Changing the drive rolls
NOTICE
• Change or reverse the drive rolls always in pairs:
• Observe the groove geometry and the wire diameter.
• The drive rolls should be changed whenever the wire type or the wire diameter are changed or the
If required, the wire must be cut through and then fed in again.
6.5 Feed in wire on page EN-11
1 Open cover at M-Drive.
2 Fold pressure lever (6) forward.
3 Swing the the pressure rockers (1) open using the pressure rolls (2).
4 Unscrew locking screws (5) from drive rolls (4).
5 Replace drive rolls (4) and re-mount them.
6 Unscrew retaining screws (5) and close pressure rockers (1) using the pressure rolls (2).
7 Fold pressure lever (6) upward.
Re-adjust contact pressure via the pressure lever (6).
8 Close the cover.
EN - 12
3
2 full-floating axles
4
2 drive rolls
drive rolls are worn out.
5
2 retaining screws
MFS-V2
2
3
4
6
Pressure lever
Capítulos
Tabla de contenido
