Replacing The Drive Rolls En - Abicor Binzel ABIDRIVE V2 Instructivo De Servicio

6 Putting into operation
6.10 Replacing the drive rolls
Risk of crushing
Hands can be pulled in and crushed by moving wheels.
• Do not reach into moving wheels.
1
2
3
Fig. 17
NOTICE
• The drive rolls should be changed whenever the wire type or the wire diameter are changed or the
• Always replace/change the drive rolls in pairs.
• Observe the groove geometry and the wire diameter.
If necessary, sever the wire and feed it in again.
 6.9 Feeding in the wire on page EN-23
1 Switch off the power to the ABIDRIVE V2 and disconnect the mains plug.
2 Open the cover on the ABIDRIVE V2.
3 Fold the pressure lever (1) forwards.
4 Swing the pressure rocker (5) open together with the pressure rolls (2).
5 Remove the full-floating axles (4) (clipped in).
6 Replace the drive rolls (3).
7 Attach the full-floating axles (4) and close the pressure rocker (5).
8 Fold the pressure lever (1) back into the vertical position.
Use the pressure lever (1) to set the necessary contact pressure.
9 Close the cover.
EN - 24
WARNING
1
5
Pressure lever
2 pressure rolls
2 drive rolls
Replacing the drive rolls
drive rolls are worn out.
2
4
3
4 2 full-floating axles
5 Pressure rocker
TIG cold-wire feeder
1