Adjusting The Awning - Dometic PERFECTWALL PW3500 Instrucciones De Uso

PW3500
7

Adjusting the awning

7.1 Resetting the outer limit
The optimum outer limit of the awning is set by default. Over time, the setting for the
outer limit can become incorrect. The awning then fails to extend fully or far enough
so that the fabric hangs down.
Reset the outer limit as follows:
➤ Extend the awning all the way until it stops.
➤ Turn the lower control knob on the motor (fig. 9 1, page 5) anti-clockwise to
extend the stop limit further.
➤ Turn the lower control knob on the motor (fig. 9 1, page 5) clockwise to reduce
the stop limit inwards.
➤ Retract and extend the awning a little to check the setting.
➤ Repeat the setting if necessary.
7.2 Reprogramming the wind sensor
The wind sensor is set to the receiver and the remote control by default. The wind
sensor must be reprogrammed in the following cases:
• If the wind sensor no longer responds.
• If the wind sensor has been replaced.
• If a new remote has been reprogrammed.
• After the receiver and remote control have been reset.
How to reprogramme the wind sensor:.
Step 1: Remove the wind sensor and sensor unit
➤ Briefly press the
✓ The awning extends all the way until it stops.
➤ Push the wind sensor (fig. 5 1, page 3) to the left on the inside of the front panel
and remove it.
➤ Unlatch the sensor unit (fig. 6 A, page 3) and take it out of the housing.
EN
button.
Adjusting the awning
17