DeWalt DWS535 Manual De Instrucciones página 18

5. Replace the oil plug and tighten securely.
6. Dispose of oil according to local, state and federal laws and
regulations.
Brushes (fig. 19)
Inspect carbon brushes regularly by
unplugging the saw, removing the end cap
(W) located above the depth adjustment
lever (B) and withdrawing the brush
assembly. Keep brushes clean and sliding
freely in their guides. Always replace a used
brush in the same orientation in the holder
as it was prior to removal.
Carbon brushes have varying symbols
stamped into their sides, and if either brush
is worn down to the line closest to the spring, the brushes must
be replaced. Use only identical D
assemblies are available at your local service center. Always
replace the end cap after inspecting or servicing brushes.The tool
should be allowed to "run in" (run at no load without a blade) for
5 minutes before use to seat new brushes. While "running in "DO
NOT TIE, TAPE, OR OTHERWISE LOCK THE TRIGGER SWITCH
ON. HOLD BY HAND ONLY.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
e
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT, recommended accessories should be used
e
with this product.
Recommended accessories for use with your tool are available at
extra cost from your local service center. If you need any assistance in
FIG. 19
W
B
WALT brushes. New brush
e
16
locating any accessory, please contact D
701 East Joppa Road, Baltimore, MD 21286, call 1-800-4-D
(1-800-433-9258) or visit our website www.dewalt.com.
repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustments (including brush inspection and replacement)
should be performed by a D
D WALT authorized service center or other qualified service
e
personnel. Always use identical replacement parts.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty
e
materials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or tool
abuse. For further detail of warranty coverage and warranty repair
information, visit www.dewalt.com or call 1-800-4-D
433-9258). This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by others. This
warranty gives you specific legal rights and you may have other
rights which vary in certain states or provinces.
In addition to the warranty, D WALT tools are covered by our:
e
1 year Free SerVICe
D WALT will maintain the tool and replace worn parts caused by
e
normal use, for free, any time during the first year after purchase.
90 Day Money baCk GuaranTee
If you are not completely satisfied with the performance of your
D WALT Power Tool, Laser, or Nailer for any reason, you can return
e
it within 90 days from the date of purchase with a receipt for a full
refund – no questions asked.
WALT Industrial Tool Co.,
e
WALT
e
WALT factory service center, a
e
WALT (1-800-
e