DeWalt DCST920 Manual De Instrucciones página 13

Fig. P
27
28
24
25
4. Remove spindle plate 30
housing. Remove any dirt and grass from the motor
housing and spindle plate.
5. Install spindle plate 30 onto the spindle
double D shaped retaining nut
inside the base of the spindle plate.
6. Align the spindle plate hole and notch, insert a
screwdriver back into the hole and thread the new
spool housing counterclockwise. Securely tighten the
new spool housing onto the spindle
Fig. Q
31
Replacing Guard (Fig. R, S, T)
An extended coverage guard is available (sold separately)
for extra coverage if desired. Use D
guard Part Number N496261.

WARNING:
without guard firmly in place.
1. Remove the spool housing as described in the
Replacing Spool Housing section.
2. Remove the 4 guard screws
29
before installing a new
29 , so the
31 on the spindle sits
29 .
29
30
WALT replacement
e
Never operate appliance
32 shown in Figure R.
Fig. R
3. Lift the guard off at an angle as shown in Figure S.
Fig. S
4. To attached a new guard, slide the tab
guard under the lip of the motor housing
34
lower the back of the guard into place as shown in
Figure T.
Fig. T
33
5. Replace and securely tighten the 4 guard screws
6. Replace the spool housing as described in the
Replacing Spool Housing section.
Repairs
The charger and battery pack are not serviceable.

WARNING:
SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and
replacement, when applicable) should be performed
by a D WALT factory service center or a D
e
authorized service center. Always use identical
replacement parts.
Register Online
Thank you for your purchase. Register your product now for:
• WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
English
32
33 of the new
, then
5
34
32 .
To assure product
WALT
e
11