Tabla de contenido
iMPORTANT SAFETY iNSTRUCTiONS
Your sewing machine
is designed
and constructed
only for HOUSEHOLD
use.
Read all instructions
before using this sewing
machine.
DANGER
-
To reduce
the risk of electric
shock:
1.
A sewing
machine
should
never be left unattended
when plugged
in. Always
unplug this sewing
machine
from the electric
outlet
immediately
after using and before
cleaning.
2.
Always
unplug before
replacing
sewing
machine
bulb. Replace
bulb with same type rated
15 Watts.
3.
Do not reach for a sewing
machine
that has fallen into water.
Unplug
immediately.
4.
Do not place or store sewing
machine
where it can fall or be pulled
into a tub or sink. Do not place
or drop into water or other
liquid.
WARNING-
To reduce
the risk of burns, fire, electric
shock,
or injury to persons:
1.
Do not allow to be used as a toy. Close attention
is necessary
when this sewing
machine
is used by or
near children.
2.
Use this sewing
machine
only for its intended
use as described
in this manual.
Use only attachments
recommended
by the manufacturer
as contained
in this manual.
3.
Never operate
this sewing
machine
if it has a damaged
cord or plug, if it is not working
properly,
if it
has been dropped
or damaged
or dropped
into water.
Return the sewing
machine
to the nearest Sears store or service
center for examination,
repair,
electrical
or mechanical
adjustment.
4.
Never operate
the sewing
machine
with any air opening
blocked.
Keep ventilation
openings
of the
sewing
machine
and foot controller
free from accumulation
of lint, dust and loose cloth.
5.
Never drop or insert any object
into any opening.
6.
Do not use outdoors.
7.
Do not operate
where
aerosol
(spray) products
are being used or where oxygen
is being administered.
8.
To disconnect,
turn all controls
to the off (" 0 ") position,
then remove
plug from outlet.
9.
Do not unplug
by pulling on cord. To unplug,
grasp the plug, not the cord.
10.
Keep fingers
away from all moving
parts. Special
care is required
around
the sewing
machine
needle.
11.
Always
use the proper
needle plate. The wrong plate can cause the needle to break.
12.
Do not use bent needles.
13.
Do not pull or push fabric while stitching.
It may deflect
the needle causing
it to break.
14.
Switch
the sewing
machine
off (" 0 ") when making
any adjustment
in the needle area, such as
threading
needle,
changing
needle, threading
bobbin
or changing
presser foot and the like.
15.
Always
unplug the sewing
machine
from the electrical
outlet when removing
covers,
lubricating,
or
when making
any other adjustments
mentioned
in the instruction
manual.
SAVE THESE iNSTRUCTiONS
When using your sewing
machine
for the first few times,
place a waste
fabric under the presser
foot
and run the machine
without
thread
for a few minutes.
Wipe away any oil which may appear.
Tabla de contenido
