Tabla de contenido
SECTION
RIB STRAIGHT
STITCH SEWnNG
Straight
Stitch
L_ Stitch width:
k_ Stitch length:
Needle thread tension:
Presser foot A:
(_ Presser foot H:
NOTE:
when using the straight
stitch foot, make sure to set
the stitch width control
at 0. Otherwise
the needle
may strike the presser foot and possibly
break.
0
Red zone
2to6
Zigzag foot
Straight Stitch foot
I
I
I
I
@
WlD'IH
!
®
Of
0
OU
®
LENGTH
I
@
®
e Starting
to Sew
Raise the presser foot and position
the fabric next to
a seam guide line on the needle plate (5/8" is most
common).
Lower the needle to the point where you want to
start.
Lower the presser foot and pull the threads
toward
the back.
Depress
the foot control.
Gently
guide the fabric along a seam guide line letting the
fabric feed naturally.
® Finishing
Sewing
To fasten the ends of a seam, press the reverse
stitch
control
and sew several reverse stitches.
Raise the presser foot.
Remove
the fabric,
draw the
threads
to the back and cut them with the thread
cutter.
The threads
are cut in a proper length for the
next seam.
Use the Seam Guide
O Guide lines
The seam guides on the needle plate are engraved
to help you measure seam width.
The lines are 0.3
cm (1/8") apart, with the 5/8" (1.6 cm) and 7/8" (2.2
cm) engraved.
>/
/
Turn
a Square
Corner
(_ Cornering guide
To turn a square
corner
1.6 cm (5/8") from the fabric
edge.
1. Stop stitching
and lower the needle by turning
the
handwheel
counterclockwise.
2. Raise the presser foot and turn the fabric to line
the edge with the 5/8" (1.6 cm) seam guide.
3. Lower the presser foot and begin stitching
in the
new direction.
Line up the fabric edge facing you with the
cornering
guide shown.
34
Tabla de contenido
