Tabla de contenido
Threading
the Machine
o Threading
the Machine
Raise the thread take-up
lever to its highest
position
by turning
the handwheel
counterclockwise.
•' Raise the presser
foot lifter.
Place a spool on the spool pin, with thread coming
off as shown.
1_ Draw the end of thread around
the upper thread
guide.
_2_ While holding the thread
near the spool,
draw the
end of the thread
down around the check
spring
holder.
(_) Firmly draw the thread
up from right to left over
the take-up
lever and down
into the take-up
lever
eye.
(_ Slide the thread
behind the needle
bar thread
guide on the left.
(_) Thread the needle from front to back or use a
needle threader.
We recommend
using the convenient
needle
threader(#200262101),
included
with your
machine.
o Drawing
up Bobbin
Thread
(_
Raise the presser foot.
Hold the needle thread
lightly with your left hand and rotate handwheel
counterclockwise
for one complete
turn.
(_
Bring the bobbin
thread
up by pulling the needle
thread
up.
(_
Pull both threads
under and to the back of the
presser foot, !eaving 10 to 15 cm (4 to 6 inches)
of thread
clear.
t
P
24
Tabla de contenido
