Hama MyVoice 600 Instrucciones De Uso página 6

• The headset and the terminal device should not be any further than
1 metre away from each other. The smaller the distance, the better.
• Ensure the headset is off.
• Device off: With the device off, press and hold the multi-
function key (1) for 3 seconds until you hear a short tone. The
LED indicator (3) lights up blue and a voice says, 'Power On'.
• Device on: Press and hold the multifunction button (1) for
approximately 3 seconds until the status LED (3) begins to
alternate between red and blue and you hear a voice say, 'Pairing'.
The headset is searching for a Bluetooth
• Open the Bluetooth
until MyVoice 600 appears in the list of Bluetooth
• Bluetooth
devices found.
®
• Select MyVoice 600 and wait until the headset is listed as
connected in the Bluetooth
Note – Bluetooth
If your terminal device requests a password to establish the
connection, enter 0000.
Note
If pairing was successful, the status LED (3) flashes blue slowly. A
voice says, 'Connected'.
• You can now use the headset.
5.2. Automatic Bluetooth
(after successful pairing)
Note
• Make sure that your Bluetooth
and Bluetooth
• For more information, please refer to the operating instructions of
your terminal device.
• Make sure that the headset is switched on.
• After the headset and terminal device have been paired, a
connection is established automatically.
• You can now use the headset.
Note
• If pairing was successful, the status LED (3) flashes blue slowly.
A voice says, 'Connected'.
• It may be necessary to change the settings on your terminal
device to enable it to automatically connect to the paired
headset.
settings on your terminal device and wait
®
settings on your terminal device.
®
password
®
connection
®
is activated.
®
connection.
®
-capable terminal device is on
®
devices found.
®
5