Tractel Dynafor DMU Manual De Instalación, De Utilización Y De Mantenimiento página 20

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 77
International Standard
IEC 61326–1 ed. 2: 2012
IEC 61311: 2007
EN
American and Canadian standards
This equipment meets the requirements of the following
Equipment standards:
• FCC part 15 Radio Frequency Devices Subpart C
Intentional Radiators
• FCC part 15 Radio Frequency Devices Subpart B
Unintentional Radiators
• RSS-GEN, RSS-210, RSS-247, RSS 102
• ICES-GEN, ICES-003
FCC
Information
Commission
Interference
Section 15.105(b)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help
No unauthorized modifications
CAUTION: This device may not be modified, altered, or
changed in any way without signed written permission
from Tractel
. Unauthorized modification may void the
®
equipment authorization from the FCC and will void the
Tractel
warranty.
®
20
Federal
Communication
Statement
47
FCC RF Radiation Exposure Statement
This device complies with FCC radiation exposure
limits set forth for general population (uncontrolled
exposure). End users must follow the specific operating
instructions for satisfying RF exposure compliance.
This transmitter meets both portable "limb" and mobile
limits as demonstrated in the radio modules FCC ID:
OVL-BL652 & OVL-RF24GHZ RF Exposure Analysis.
This transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter
product procedures
IC Information
This device complies with Industry Canada license-
CFR
exempt RSS & ICES standard(s). Operation is subject
to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including
interference that may cause undesired operation of
the device.
Under
Industry
transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the
transmitter by Industry Canada.
To reduce potential radio interference to other users,
the antenna type and its gain should be so chosen
that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful
communication.
This device complies with Industry Canada radiation
exposure
limits
environment (uncontrolled exposure). End users must
follow the specific operating instructions for satisfying
RF exposure compliance. This transmitter meets both
portable "limb" and mobile limits as demonstrated in the
radio modules IC: 3619A-BL652 & 3619A-RF24GHZ RF
Exposure Analysis and SAR test report. This transmitter
must not be co-located or operating in conjunction with
any other antenna or transmitter.
Japan
This product contains the listed radio equipment,
which is certified according to the Japanese standard
concerning compliance with technical regulations and
conformity with Japanese radio laws.
The radio module's label bears the Giteki mark, as well
as our certificate number valid in Japan, 217-220461.
Canada
regulations,
this
set
forth
for
an
uncontrolled
radio
loading