AXXAIR GA10-M1 Manual De Instrucciones página 36

INNOVATIVE ORBITAL SOLUTIONS
Tighten the tube
Rotate the knob to put the stop contact with the tube,
then back slightly with the knob, without losing the
contact with the tube, to make up the gap of the
thread of the stop
Rotate the scale ring only to align
the "0" with the bearing mark,
then lock in position
The setting of "0" is complete.
This operation is to be performed at each
change of milling head.
Join experience
Position lock screw
(BTR key provided)
SAS au capital de 135 720 € - RCS Romans B414 581 363 – Code APE 2841 Z – Siret 414 581 363 00028 – TVA FR13414 581 363
Raise the penetration lever
330B Route de Portes Les Valence - 26800 Etoile sur Rhône
Tél: +33 475 575 070 - [email protected] - www.axxair.com
English
- 36 -