Idiomas disponibles
Idiomas disponibles
2. Use a Torx 20 screwdriver to remove the
cover.
3. Clean the glass cover.
4. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
12. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem description
You cannot activate or operate the
appliance.
The appliance does not heat up.
The lamp is turned off.
The appliance does not retain the
water drawer after you insert it.
Water comes out of the water
drawer.
The water drawer is difficult to
clean.
There is no water inside the grill -/
roasting pan after descaling.
There is dirty water on the bottom
of the cavity after descaling.
There is too much water on the
bottom of the cavity after cleaning.
Cleaning performance is not satis‐
factory.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.
5. Install the metal frame and the seal.
6. Install the left shelf support.
Cause and remedy
The appliance is not connected to an electrical supply or it is connected in‐
correctly.
The clock is not set.
To set the clock refer to "Clock functions" chapter.
The door is not closed correctly.
The fuse is blown.
Make sure the fuse is the cause of the problem. If the problem recurs, con‐
tact a qualified electrician.
Child Lock is activated.
The lamp is burnt out. Replace the lamp.
For details refer to "Care and Cleaning" chapter.
You did not fully press the water drawer body.
Fully insert the water drawer into the appliance.
You did not assemble the lid of the water drawer or wave breaker correctly.
Reassemble the lid of the water drawer and wave breaker.
Mare sure that the lid and the wave breaker are removed before you start
cleaning.
The water drawer was not filled in to the maximum level.
Check if a descaling agent / water is present in the water drawer body.
The grill -/ roasting pan is on a wrong shelf position.
Remove the remaining water and the descaling agent from the bottom of the
appliance. Next time put the grill -/ roasting pan on the first shelf position.
You put too much detergent in the appliance before you started cleaning.
Next time evenly spread the thin layer of a detergent on the cavity walls.
You started cleaning when the appliance was too hot.
Wait for the appliance to cool down. Repeat cleaning.
You did not remove all the accessories from the appliance before cleaning.
Remove all the accessories and repeat cleaning.
Tighten the screws.
ENGLISH
25
