Kratki K7 Manual De Usuario página 13

removed on a regular basis. if not removed, the creosote layer inside the flue insert damages the pac-
king and leads to corrosion. the components of the freestanding stove that are made from cast iron
include: upper plate, lower plate, rear wall, side walls, left and right grates, door frame, door, exhaust
outlet, lid, leg, fence, rear cover, side cover and deflector.
Operation
- Always observe the user manual;
- During the first lightings use only moderate amounts of wood to ensure the proper operation of the
entire system. Gradually increase wood batches on subsequent days;
- Do not use the unit to incinerate rubbish or waste;
- Use only the recommended fuel – SEE ThE RATING PLATE (at the end of the user manual –
technical parameters of the unit);
- Do not use the stove if the glass is broken or cracked. Replace the glass before reuse.
You had better contact the unit's vendor for this purpose. it is recommended to replace the glass and
door gaskets when replacing the glass. Do not tighten the screws too closely so that the glass could
freely expand;
- After prolonged stoppage make sure that the flue, the connecting pipe and the exhaust system of
the unit are open.
Technical Parameters
See the rating plate, complete documentation – www.kratki.eu
Maintenance Rules
the way in which the fireplace is operated and the quality of the wood used for burning have a funda-
mental impact on the phenomena occurring inside the hearth. therefore, it is necessary to check and
maintain the stove and its components on a regular basis. Before each heating season you have to
inspect and clean the whole stove.
Particular attention should be drawn to the condition of the gaskets; they should be replaced if ne-
cessary. to reduce creosote accumulation, it is recommended to set the hearth from time to time to
the maximum combustion while leaving the door closed. to clean the flue, use only the equipment
intended for this purpose. the user is obliged to clean the flue in accordance with applicable laws.
NOTE! Heat-proof paint is not resistant to humidity.
Ash Removal
the ash does not spill out if the ashpan is emptied on a regular basis. Do not allow the ash to touch the
grate bottom (this prevents air flow that is necessary for combustion). the ash should be poured into
a metal container with a tight lid.
Glass Cleaning
the glass heats up to high temperatures; it can be cleaned only when the stove is put out. Do not use
abrasive materials for this purpose. the window is made from special glass that is resistant to tempe-
ratures of up to 650°c during continuous burning. every time close the door using the handle. Do not
light the fire too close to the glass. Do not use combustible liquids, fat or any other unsuitable products
to facilitate lighting. it is recommended to remove the handle for the safety of the insert's user.
NOTE! From time to time lubricate the abrasive surfaces of the door hinges and the locking device
with graphite grease.
WARRANTY TERMS AND CONDITIONS
Scope of Warranty:
the manufacturer warrants the efficient operation of the unit in accordance with the technical and
performance specifications contained in this warranty. the use of the stove, the way in which it is con-
nected to the piping system and the operational conditions have to be as described in this user manu-
al. the unit should be installed by a properly qualified professional. the warranty includes free repair of
the unit within five years after its purchase. warranty claims can be raised starting from the purchase
13